A recessed light sometimes called a can light has both its housing and bulb recessed above the ceiling drywall.
Replacing ceiling lights with recessed lights.
Typically the hole left by a recessed fixture is larger than most caps making necessary the use of a ceiling medallion to cover difference.
Recessed lighting is ideal for kitchens and it s what you ll find in most new homes.
Attach ceiling medallion with clean release tape.
This temporarily secures medallion in place while finishing installation of fixture.
The excess wire gives you enough slack to wire the new fixtures.
The first step to replacing these recessed lights is to remove the light bulb by simply unscrewing it from the socket.
Repeat this for each light fixture.
Converting a standard ceiling light fixture to a recessed light involves removing the old fixture and its electrical box and installing the new recessed light usually in the same place.
Thanks so much i am so looking forward to.
Remove the light bulbs from the fixture.
When replacing recessed lighting with flush mount lighting the most important issue is what to do with the hole in the ceiling left behind by the recessed lighting fixture.
Then you ll know what your options are.
The first thing you need to do is identify the type of ceiling you have.
Whether or not you patch the.
Unless you re extraordinarily tall you ll probably need a step ladder for this project.
Learning how to replace recessed lighting is not difficult with a recessed lighting conversion kit.
Let s look at a few options for replacing your old lights with modern recessed lighting.
Remove screws securing the fixture to the ceiling box and lower.
A medallion is not needed if installing a ceiling mount fixture.
In most cases a flush mount light fixture will cover the hole occupied by the recessed fixture.
Many people find value in undertaking recessed lighting conversion.
Pull cable from the power source to the first recessed light and leave approximately 18 inches of wire hanging from the ceiling.
Turn off the circuit breaker on the service panel for the light circuit being worked on.